Removal & Installation
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2002 GMC Savana Special, 2002 GMC Savana Camper Special, 2002 GMC Savana, 2002 GMC C3500 HD, and 2002 Chevrolet RV Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
On vans, remove the engine cover. See ENGINE COVER . On all models, remove the harness connector from the boost sensor by releasing the locking tab. Remove the mounting bolts. Remove the sensor. Install the port gasket on the sensor. To complete installation, reverse removal procedure. Tighten fasteners properly. See TORQUE SPECIFICATIONS .