LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 878 (Heating, Ventilation And Air Conditioning) >> Repair Instruction >> Compressor Pressure Relief Valve Install (V5 - Conventional Mount)

Compressor Pressure Relief Valve Install (V5 - Conventional Mount)

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the valve seat area on the rear head.
  2. Lubricate the O-ring of the new pressure relief valve and the O-ring assembly using new 525 viscosity refrigerant oil.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  3. Install the new pressure relief valve (2).

    Tighten 

    Tighten the valve to 9 N.m (80 lb in).

    Fig 1: Identifying Pressure Relief Valve (V5 - Conventional Mount)
    G01568554Courtesy of GENERAL MOTORS CORP.
  4. Perform a leak test. Refer to COMPRESSOR LEAK TESTING (V5 DIRECT MOUNT)  or COMPRESSOR LEAK TESTING (V5 - CONVENTIONAL MOUNT)  .
scientia non olet · About LEMON Manuals