Clutch Rotor and/or Bearing Replacement (V-5 Conventional Mount): Notes

WARNING: This page is about a different car, the 2003 Buick Regal and 2003 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.

Tools Required

J 6083 External Snap Ring Pliers. See Special Tools and Equipment .
J 8092 Universal Driver Handle. See Special Tools and Equipment .
J 8433-1 Puller Bar. See Special Tools and Equipment .
J 8433-3 Forcing Screw. See Special Tools and Equipment .
J 9398 Rotor Bearing Remover. See Special Tools and Equipment .
J 9481-A Bearing Installer. See Special Tools and Equipment .
J 21352-A Support Block. See Special Tools and Equipment .
J 33017 Pulley and Bearing Installer. See Special Tools and Equipment .
J 33019 Pulley Bearing Staking Tool. See Special Tools and Equipment .
J 33023-A Puller Pilot. See Special Tools and Equipment .
J 34992 Compressor Holding Fixture. See Special Tools and Equipment .
J 33020 Pulley Puller. See Special Tools and Equipment .