LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Door System, Mirror System & Window System) >> Repair Instructions >> Lock Actuator Replacement - Power Sliding Door >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sliding door inner trim panel. Refer to Trim Panel Replacement - Side Rear Door .
  2. Remove the sliding door water deflector. Refer to Water Deflector Replacement - Sliding Door .
  3. Disconnect the powersliding door latch release actuator electrical connector.
  4. Remove the powersliding door latch release actuator screws.
  5. Remove the powersliding door latch release actuator.
  6. Unhook the powersliding door latch release actuator rod from the powersliding door latch release actuator.
    Fig 1: Removing Powersliding Door Latch Release Actuator & Screws
    G01814109Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals