LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 876 (Door System, Mirror System & Window System) >> Repair Instructions >> Door Front Edge In/Out Adjustment - Sliding >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the sliding door upper garnish molding. Refer to GARNISH MOLDING REPLACEMENT - SLIDING DOOR .

    Important:  Loosen only 1 bolt at a time on the following brackets:

    • The sliding door lower roller bracket
    • The sliding door upper roller bracket

    If you loosen more than 1 bolt at a time, you may cause a loss of sliding door alignment.

  2. Loosen 1 bolt on the sliding door upper roller bracket.
  3. Loosen 1 bolt on the sliding door lower bracket.
  4. Adjust the front edge of the sliding door in or out, as needed.
scientia non olet · About LEMON Manuals