Exiting On-Board Diagnostics
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
When exiting the on-board diagnostics any DTCs stored by the rear side door actuator control module will be erased. In order to review the DTCs, diagnostic mode 1 may be entered from mode 3 by pressing the power sliding door open/close switch for 4 seconds. The on-board diagnostics may be exited from diagnostic modes 1 or 3 by turning power door on/off switch to the off position for a minimum of 10 seconds. After exiting the on-board diagnostics the power sliding door must be re-initialized. Refer to Power Sliding Door (PSD) Re-Initialization .