Entering On-Board Diagnostics
WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
The on-board diagnostic modes can only be entered in a sequential order from modes 1-3.
- Enter the right power sliding door system on-board diagnostics using the right B-pillar open/close switch and the right on/off switch in the overhead console.
- Enter the left power sliding door system on-board diagnostics using the left B-pillar open/close switch and the left on/off switch in the overhead console.
- Both power sliding doors must be closed and in the latched position.
- Place the on/off switch in the overhead console to the OFF position.
- Press and hold the B-pillar power sliding door open/close switch.
- While holding the open/close switch, operate the on/off switch through 10 ON and OFF cycles within 10 seconds stopping in the on position.
- The sliding door alarm will sound 1 long tone indicating diagnostic mode 1 is active.