LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 874 (Body Rear End) >> Repair Instructions >> Pressure Relief Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the pressure relief valve to the body.
  2. Push in the pressure relief valve in order to secure the retainers into the body.
  3. Install the rear accessory panel. Refer to ACCESSORY PANEL REPLACEMENT - REAR .
  4. Install the rear bumper fascia. Refer to FASCIA REPLACEMENT - REAR BUMPER (OLDSMOBILE) or FASCIA REPLACEMENT - REAR BUMPER (PONTIAC) .
    Fig 1: Installing Pressure Relief Valve
    G01814584Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals