LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 865 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the stabilizer link into the vehicle.
    NOTE: Refer to FASTENER NOTICE .
  2. Install the stabilizer shaft link bolt and nut.

    Tighten 

    Tighten the stabilizer shaft link nut to 23 N.m (17 lb ft).

  3. Install the tire and wheel assembly. Refer to TIRE AND WHEEL REMOVAL AND INSTALLATION .
  4. Lower the vehicle.
    Fig 1: Installing Stabilizer Shaft Link Bolt & Nut
    G01828300Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals