LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 860 (Engine Mechanical (Repair Instructions 3 Of 3) - 5.7L) >> Off-Vehicle Repair Instructions - Part 3 >> Throttle Body Installation

Throttle Body Installation

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Throttle Body Gasket & Intake Manifold
    GM1272781Courtesy of GENERAL MOTORS CORP.
    NOTE: Handle the electronic throttle control components carefully. Use cleanliness in order to prevent damage. Do not drop the electronic throttle control components. Do not roughly handle the electronic throttle control components. Do not immerse the electronic throttle control components in cleaning solvents of any type.
    IMPORTANT: DO NOT use the throttle body gasket again. Install a NEW gasket during assembly.
  1. Install the throttle body gasket (509) to the intake manifold.
    2. Fig 2: View Of Throttle Body
    GM43567Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the throttle body and bolts.

    Tighten:  Tighten the throttle body bolts to 12 N.m (106 lb in).

  3. Install the engine coolant air bleed hose and clamp.
scientia non olet · About LEMON Manuals