Vibration Analysis - Driveline
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Vibration Analysis - Driveline
| Step | Action | Yes | No |
|---|---|---|---|
| 1 | Has the Vibration Analysis - Road Testing table been completed? | Go to Step 2 | Go to Vibration Analysis - Road Testing |
| 2 | Did you record frequency data from the J 38792-A during the Vibration Analysis - Road Testing procedure? See Special Tools and Equipment . | Go to Step 3 | Go to Step 5 |
| 3 | Based on the Vibration Analysis - Road Testing table, is the concern first order driveline related? | Go to Step 4 | Go to Step 5 |
| 4 | Inspect the rear drive axle for proper operation. Refer to Diagnostic Starting Point - Rear Drive Axle
in Rear Drive Axle. Did you find and correct a condition? |
Go to Step 6 | Go to Step 2 |
| 5 | Based on the Vibration Analysis - Road Testing table, is the concern a noise that is not felt? | Go to Vibration Diagnostic Aids | Go to Vibration Analysis - Road Testing |
| 6 |
|
Go to Step 2 | System OK |