LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 846 (Suspension System General Diagnosis) >> Diagnostic Information and Procedures >> Trim Height Inspection Procedure >> D Height Adjustment

D Height Adjustment

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Retainers & Top Of Spring Bolts
    GM192478Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: One complete turn of the adjustment bolt is equal to 2 mm (5/64 in).
  1. Remove the retainers (1) on the top of the spring bolts (2).
  2. Adjust the D trim height by turning the spring bolt.
  3. Measure the D trim height again.
    4. Fig 2: Measuring The Rear Spring Stud Heights
    GM200316Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not exceed the maximum difference between the right and left rear spring stud heights.
  4. Measure the rear spring stud heights (1), the maximum difference should be 5 mm (0.196 in).
  5. Install the retainers to the bolts.
  6. Lower the vehicle.
scientia non olet · About LEMON Manuals