LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 836 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front (Coupe, Hardtop) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Guide, Bolt & Seat Belt Retractor
    GM63763Courtesy of GENERAL MOTORS CORP.
  1. Uncover the upper guide bolt by pushing up at the belt edge of the cover and flipping up the cover.
  2. Remove the upper guide bolt.
    3. Fig 2: Side Sill Trim Plate
    GM71211Courtesy of GENERAL MOTORS CORP.
  3. Remove the side sill trim plate. Refer to Door Sill Plate Replacement in Interior Trim.
    4. Fig 3: Lock Pillar Trim Panel
    GM71212Courtesy of GENERAL MOTORS CORP.
  4. Remove the lock pillar trim panel. Refer to Trim Replacement - Lock Pillar (Upper Convertible) or Trim Replacement - Lock Pillar (Coupe) or Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) in Interior Trim.
    5. Fig 4: Upper Guide, Bolt & Seat Belt Retractor
    GM63763Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolt, mounting the upper retractor.
  6. Remove the bolt, mounting the lower retractor.
  7. Remove the retractor side of the seat belt.
scientia non olet · About LEMON Manuals