LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 836 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - Left Front (Convertible) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Seat Belt Guide Bracket Stud & Upper Guide
    GM213980Courtesy of GENERAL MOTORS CORP.
  1. Open the upper guide bolt cover by prying up at the belt side of the cover.
  2. Remove the nut attaching the upper guide to the seat belt guide bracket stud.
  3. Remove the upper guide from the stud.
    4. Fig 2: Lock Pillar Upper Trim Panel
    GM214020Courtesy of GENERAL MOTORS CORP.
  4. Remove the washer and spacer from the stud.
  5. Remove the screw attaching the lock pillar upper trim panel.
  6. Remove the lock pillar upper trim panel.
    7. Fig 3: Lock Pillar Lower Trim Panel
    GM214018Courtesy of GENERAL MOTORS CORP.
  7. Remove the sill plate trim.
  8. Remove the lock pillar lower trim panel.
    9. Fig 4: Retractor Side Seat Belt
    GM280813Courtesy of GENERAL MOTORS CORP.
  9. Remove the bolt attaching the upper retractor.
  10. Remove the bolt attaching the lower retractor.
  11. Remove the retractor side of the seat belt.
scientia non olet · About LEMON Manuals