Conditions for Clearing the DTC
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- A current DTC Last Test Failed clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic.
- Clear the DTC with a scan tool.
DTC P1114
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module (PCM) Connector End Views or Engine Controls Connector End Views |
|||
| 1 | Did you perform the Diagnostic System Check-Engine Controls? | Go to Step 2 | Go to Diagnostic System Check - Engine Controls |
| 2 | Observe the DTC information with a scan tool. Is DTC P0117 set? |
Go to DTC P0117 | Go to Step 3 |
| 3 | Observe the engine coolant temperature (ECT) sensor parameter with a scan tool while moving the ECT sensor connector and the powertrain control module (PCM) connector. Refer to Inducing Intermittent Fault Conditions
in Wiring Systems. Does the scan tool indicate an abrupt change in value? |
Go to Step 5 | Go to Step 4 |
| 4 | Observe the ECT parameter with a scan tool while moving the wiring harness at the ECT sensor and the PCM. Refer to Inducing Intermittent Fault Conditions
in Wiring Systems. Does the scan tool indicate an abrupt change in value? |
Go to Step 6 | Go to Step 7 |
| 5 | Repair the ECT connector or the terminal as necessary. Refer to Connector Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 7 | - |
| 6 | Repair the ECT wiring or the wiring harness as necessary. Refer to Wiring Repairs
in Wiring Systems. Did you complete the repair? |
Go to Step 7 | - |
| 7 |
|
Go to Step 2 | Go to Step 8 |
| 8 | Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? |
Go to Diagnostic Trouble Code (DTC) List | System OK |