LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 832 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Engine Oil Temperature Gage Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Engine Oil Temperature Gage Sensor
    GM697015Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the engine oil temperature gage sensor.

    Tighten:  Tighten the engine oil temperature gage sensor to 23 N.m (17 lb ft).

  2. Lower the vehicle.
scientia non olet · About LEMON Manuals