LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 832 (Engine Mechanical (Repair Instructions 1 Of 3) - 5.7L) >> Repair Instructions (On-Vehicle & Off-Vehicle - Part 1 >> On-Vehicle Repair Instructions >> Engine Oil Pressure Sensor and/or Switch Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: MAP Sensor Vacuum Hose & MAP Sensor Electrical Connector
    GM651870Courtesy of GENERAL MOTORS CORP.
  1. Remove the intake manifold. Refer to Intake Manifold Replacement .
  2. Disconnect the oil pressure sensor electrical connector (2).
    3. IMPORTANT: Clean the area around the sensor before removal. This avoids debris from entering the engine.
    Fig 2: J 41712 & Oil Pressure Sensor
    GM43569Courtesy of GENERAL MOTORS CORP.
  3. Use J 41712 to remove the oil pressure sensor from the engine block.
scientia non olet · About LEMON Manuals