LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 830 (Folding Roof System) >> Repair Instructions >> Weatherstrip Replacement - Folding Top (Rear Side Rail) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper & Lower Corners Of Weatherstrip Retainer
    GM284768Courtesy of GENERAL MOTORS CORP.
  1. Apply a bead of sealer GM P/N 12345739 (Canadian P/N 10953472), to the upper and lower corners of the weatherstrip retainer.
  2. Fig 2: Rear Weatherstrip & Center Rail Side Weatherstrip
    GM284771Courtesy of GENERAL MOTORS CORP.
  3. Remove the protective film from the adhesive on the back of the weatherstrip.
  4. Install the weatherstrip to the rear side rail retainer.
  5. Install the rear weatherstrip into the end of the center rail side weatherstrip.
  6. Install the push-in retainer to the bottom of the weatherstrip.
  7. Reposition the folding top to the original position.