Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Forward End Of Front Side Weatherstrip Retainer

Courtesy of GENERAL MOTORS CORP.

Apply sealer GM P/N 12345739 (Canadian P/N 10953472), or equivalent to the forward end of the front side weatherstrip retainer (1).

Fig 2: Front Upper Corner

Courtesy of GENERAL MOTORS CORP.

Apply a bead of sealer GM P/N 12345739 (Canadian P/N 10953472), or equivalent 6 mm (2.4 in) high around the front side retainer (1) in the following places:
- At the front upper corner (3)
- On both sides (2)

Fig 3: Center Side Retainer & Weatherstrip

Courtesy of GENERAL MOTORS CORP.

Apply a drop of sealer GM P/N 12345739 (Canadian P/N 10953472), or equivalent (3) 12 mm (0.5 in) in diameter to the screw heads of the center side retainer.
Remove the protective film from the adhesive on the weatherstrip.

Fig 4: Weatherstrip Screws At Right & Left Front Side Rail

Courtesy of GENERAL MOTORS CORP.

Install the side rail weatherstrip, as necessary.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the screw to the front side rail weatherstrip.
Tighten: Tighten the screw to 4 N.m (35 lb in).
Reposition the top to the original position.