Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the striker and the shims to the lid with the arrow on the striker pointed downward.
- Install the bolts attaching the striker, beginning with the driver side bolt.
Tighten: Tighten the bolts to 10 N.m (89 lb in).
- Inspect the operation of the compartment lid.
- Close the compartment lid.
NOTE:
Refer to Fastener Notice in Cautions and Notices.