LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 830 (Folding Roof System) >> Repair Instructions >> Folding Top Cover No. 1 Bow Retainer Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Folding Top With The #1 Bow And The #5 Bow Up
    GM289910Courtesy of GENERAL MOTORS CORP.
  1. Position the folding top with the #1 and #5 bow up.
  2. Remove the seal compression panel. Refer to Folding Top Seal Compression Panel Replacement .
    3. Fig 2: Top Cover Staples To Bow
    GM784488Courtesy of GENERAL MOTORS CORP.
  3. Use a pair of needle nose pliers to remove the top cover staples from the bow.
    4. Fig 3: Headliner Staples To Bow
    GM784495Courtesy of GENERAL MOTORS CORP.
  4. Use a pair of needle nose pliers to remove the headliner staples from the bow.
    5. CAUTION: Refer to Safety Glasses Caution in Cautions and Notices.
  5. From the top of the bow, drill out the rivets from the top cover retainer.
  6. Remove the top cover retainer.
scientia non olet · About LEMON Manuals