Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Nuts At Reflector

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the nuts attaching the reflector to the fascia.
Tighten: Tighten the reflector nuts to 2.3 N.m (20 lb in).

Fig 2: Screws At Inner Taillamp

Courtesy of GENERAL MOTORS CORP.

Install the taillamp to the fascia opening.
Install the taillamp screws.
Tighten: Tighten the taillamp screws to 2 N.m (18 lb in).