LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 828 (Bumper System) >> Repair Instructions >> Fascia Grille Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wiring Harness' Retainer Clips & Fascia Grille
    GM721294Courtesy of GENERAL MOTORS CORP.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the front brake caliper cooling duct. Refer to Brake Caliper Cooling Duct Replacement - Front  .
  3. Remove the wiring harness' retainer clips (1).
  4. Remove the clips at the top of the fascia grille (2).
  5. Remove the fascia grille screws.
    6. Fig 2: Fascia Grille At Front Of The Fascia Opening
    GM721297Courtesy of GENERAL MOTORS CORP.
  6. Remove the fascia grille through the front of the fascia opening.
scientia non olet · About LEMON Manuals