Radial Tire Lead/Pull Correction
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Radial Tire Lead/Pull Correction
| Step | Action | Yes | No |
|---|---|---|---|
| DEFINITION: Lead/pull is the deviation of the vehicle from a straight path on a level road with no pressure on the steering wheel. | |||
| 1 | Did you perform the Vehicle Leads/Pull diagnostic table in Suspension General Diagnosis? | Go to Step 2 | Go to Vehicle Leads/Pulls in Suspension General Diagnosis |
| 2 | Road test the vehicle to verify the concern. Select a smooth level surface to perform the test. Does the condition exist? |
Go to Step 3 | System OK |
| 3 | Cross-switch the front tire and wheel assemblies. Did you complete the procedure? |
Go to Step 4 | - |
| 4 | Does the vehicle lead/pull in the opposite direction? | Go to Step 5 | Go to Measuring Wheel Alignment in Wheel Alignment |
| 5 | Replace the tire that is pulling in the opposite direction and then install it to its original position. Refer to Tire Mounting and Dismounting . Did you complete the replacement? |
Go to Step 6 | - |
| 6 | Verify proper vehicle operation. Does the original condition still exist? |
Go to Step 1 | System OK |