LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 825 (Body Front End) >> Repair Instructions >> Seal Replacement - Hood Rear >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Plenum To Hood Seal
    GM71296Courtesy of GENERAL MOTORS CORP.
  1. Position the seal on the plenum panel.
    • The lip of the seal facing rearward
    • The left end of the seal tight to the wheelhouse panel
  2. Press the seal onto the flange of the plenum panel.
  3. Close the hood.
scientia non olet · About LEMON Manuals