Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Position the air temperature actuator, then align the slots in the actuator driver to the flats on the temperature door shaft.
- Slide the air temperature actuator onto the shaft, while aligning the actuator locating hole to the forward alignment pin on the HVAC module case.
The actuator should be completely seated onto the temperature door shaft and be the actuator mounting holes should be flush with the mounting bosses on the HVAC module case.
- Install the temperature actuator retaining screws.
Tighten: Tighten the screws to 1.5 N.m (13 lb in).
- Connect the air temperature actuator electrical connector.
- Install the inside air temperature sensor aspirator duct muffler.
Use a twisting motion to secure the duct muffler.
- Install the inside air temperature sensor aspirator duct.
- Use a twisting motion to secure the duct to the duct muffler.
- Install the duct retaining tab to the ignition switch housing bracket.
- Install the Bose amplifier. Refer to Bose Module Replacement in Entertainment.
- Install the front floor kick-up panel. Refer to Kick-Up Panel Replacement - Front Floor in Interior Trim.
- Recalibrate the actuators. Refer to Re-Calibrating Actuators .
NOTE:
Refer to Fastener Notice in Cautions and Notices.