LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 82 (Engine Controls - Removal & Installation, Overhaul) >> Ignition Systems >> Crankshaft Position Sensor >> Removal (3.1L - CKP Sensor "B")

Removal (3.1L - CKP Sensor "B")

WARNING: This page is about a different car, the 2002 Pontiac Grand Prix, 2002 Chevrolet Monte Carlo, 2002 Chevrolet Impala, 2002 Buick Regal, and 2002 Buick Century. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Crankshaft Position (CKP) sensor "B" may also be referred to as CKP sensor 7X. CKP sensor is mounted in cylinder block. See Figure. Turn the steering wheel fully to the left. Raise and support the vehicle. Remove the right front tire and wheel.
  2. Disconnect the CKP sensor electrical connector. Remove the CKP sensor attaching bolt. Remove the CKP sensor from the engine. Inspect for wear, cracks, or leakage if the sensor is not being replaced.
scientia non olet · About LEMON Manuals