LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 818 (Body Rear End) >> Repair Instructions >> Lock Striker Replacement - Rear Compartment Lid >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Striker At Lid
    GM213993Courtesy of GENERAL MOTORS CORP.
  1. Position the striker to the lid with the arrow pointed down.
  2. Install the left side bolt first. (net locating hole).
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the right side bolt.

    Tighten:  Tighten the rear compartment lid latch striker bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals