LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 818 (Body Rear End) >> Diagnostic Information and Procedures >> Rear Compartment Lid Ajar Indicator Inoperative

Rear Compartment Lid Ajar Indicator Inoperative

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
Rear Compartment Lid Ajar Indicator Inoperative

Step Action Yes No
Schematic Reference:  Body Rear End Schematics  
1 Did you review the Body Rear End description and operation and perform the necessary inspections? Go to Step 2  Go to Luggage Compartment Description and Operation 
2 Open the rear hatch.
Is the hatch ajar indicator illuminated?		 Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems Go to Step 3 
3
  1. Install a scan tool.
  2. Turn the ignition ON with the engine OFF.
  3. With a scan tool observe the hatch ajar switch signal parameter in the BCM Input Data 2 data list.
Does the scan tool display open?		 Go to Step 12  Go to Step 4 
4
  1. Disconnect the rear compartment lid latch.
  2. Connect a fused jumper between the rear compartment lid latch ajar signal circuit and a good ground.
  3. With a scan tool observe the rear compartment ajar switch signal parameter in the BCM Input Data 2 data list.
Does the scan tool display open?		 Go to Step 5  Go to Step 6 
5
  1. Connect a fused jumper between the rear compartment lid latch ajar signal circuit and the rear compartment lid latch ajar ground circuit.
  2. With a scan tool observe the rear compartment ajar switch signal parameter in the BCM Input Data 2 data list.
Does the scan tool display open?		 Go to Step 8  Go to Step 9 
6 Test the signal circuit of the rear compartment lid latch ajar signal circuit for an open or high resistance. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 13  Go to Step 7 
7 Inspect for poor connections at the harness connector of the body control module. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 13  Go to Step 10 
8 Inspect for poor connections at the harness connector of the rear compartment lid latch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 13  Go to Step 11 
9 Repair the open or high resistance in the ground circuit of the folding top lid latch. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.
Did you find and correct the condition?		 Go to Step 13  -
10
IMPORTANT: When replacing the body control module refer to Body Control Module (BCM) Programming/RPO Configuration in Body Control System.
Replace the body control module. Refer to Body Control Module Replacement in Body Control System.Did you complete the replacement?		 Go to Step 13  -
11 Replace the rear compartment lid latch(s). Refer to Rear Compartment Lid Switch Replacement (Domestic)  or Rear Compartment Lid Switch Replacement (Export) .
Did you complete the replacement?		 Go to Step 13  -
12 Replace the instrument cluster. Refer to Driver Information Center Switch Replacement in Instrument Panel, Gages, and Console.
Did you complete the replacement?		 Go to Step 13  -
13 Operate the system in order to verify the repair.
Did you correct the condition?		 System OK Go to Step 3 
scientia non olet · About LEMON Manuals