LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 813 (Interior Trim) >> Repair Instructions >> Trim Replacement - Lock Pillar (Lower Convertible and Hard Top) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Upper Lock Pillar Trim Panel To Rear Side Panel
    GM333454Courtesy of GENERAL MOTORS CORP.
  1. Route the seat belt through the lock pillar trim panel.
  2. Position the lower lock pillar trim panel under the upper lock pillar trim panel (convertible), side trim panel (hard top).
  3. Install the foam insulator behind the lock pillar trim.
  4. Position the lock pillar trim panel retainers to the holes in the lock pillar and the side rail.
    5. Fig 2: Lock Pillar Trim Panel To Lock Pillar & Side Rail
    GM214018Courtesy of GENERAL MOTORS CORP.
  5. Push in on the panel securing the retainers.
  6. Install the sill plate. Refer to Door Sill Plate Replacement .
scientia non olet · About LEMON Manuals