LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 813 (Interior Trim) >> Repair Instructions >> Trim Panel Carpet - Rear Compartment Rear Center (Hardtop) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Convenience Net Nuts
    GM376664Courtesy of GENERAL MOTORS CORP.
  1. Install the rear compartment rear trim panel to the studs on the rear body panel.
  2. Route the manual release cable down behind the carpet trim panel and out through the slit in the trim panel into the floor stowage area.
  3. Tuck the trim panel upper flange under the rim of the rear panel.
  4. Install the convenience net installation nuts.
  5. Fig 2: View Of Cargo Lamp Assembly
    GM64673Courtesy of GENERAL MOTORS CORP.
  6. Install the cargo lamps.
  7. Tuck the rear trim behind the sides of the floor carpet.
  8. Fig 3: Floor Center Stowage Cover
    GM376660Courtesy of GENERAL MOTORS CORP.
  9. Install the floor center stowage cover.