Installation Procedure
WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
- Twist to install the bulb/socket to the IPC.
- Tilt the circuit board back toward its mounting position.
Tilt the board slowly, and make sure the flat wires do not become kinked or loose.
- Connect the chime connector to the circuit board.
- Tilt the circuit board the rest of the way to its mounting position.
- Snap the circuit board tabs into place.
- Install the circuit board retaining screws.
- Connect the (side) electrical connector to the circuit board.
- Position the IPC rear cover.
- Snap the IPC rear cover into place.
- Install the IPC rear cover retaining screws.
Tighten: Tighten the IPC rear cover retaining screws to 0.7 N.m (6 lb in).
- Connect the electrical connectors to the circuit board.
- Install the UV inverter to the IPC rear cover.
Align the UV inverter onto the rear cover alignment pins.
- Install the UV inverter mounting screws.
Tighten: Tighten the UV inverter mounting screws to 0.7 N.m (6 lb in).
- Connect the UV inverter electrical connectors.
- Install the UV inverter wiring covers.
- Align the covers on the alignment pins.
- Snap the covers into place.
- Install the IPC to the vehicle. Refer to Instrument Panel Cluster (IPC) Replacement .
NOTE:
Refer to Fastener Notice in Cautions and Notices.