LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 811 (Instrument Panel System Displays, Gauges And Console) >> Repair Instructions >> Compartment Replacement - Instrument Panel (I/P) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: I/P Compartment To Wiring Harness Connector
    GM636321Courtesy of GENERAL MOTORS CORP.
  1. Connect the wiring harness connector to the inflatable restraint I/P module switch connector.
    2. Fig 2: Instrument Panel (I/P) Passenger Compartment Door
    GM636341Courtesy of GENERAL MOTORS CORP.
  2. Install the I/P compartment.
  3. Loosely install the screw which retains the side of the I/P compartment, in order to align the nut on the passenger SIR bracket.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the upper retaining screw to the I/P compartment.

    Tighten:  Tighten the retaining screw to 1.9 N.m (17 lb in).

  5. Install the lower retaining bolts to the I/P compartment.

    Tighten:  Tighten the retaining bolts to 12 N.m (106 lb in).

    6. Fig 3: Electrical Connector To I/P Compartment Lamp Switch
    GM174192Courtesy of GENERAL MOTORS CORP.
  6. Align and hold the I/P compartment to the I/P, then install the side retaining screw to the I/P compartment.

    Tighten:  Tighten the retaining screw to 1.9 N.m (17 lb in).

  7. Install the trim plugs to the I/P compartment door.
  8. Connect the electrical connector to the I/P compartment lamp switch.
  9. Close the I/P passenger compartment door.
scientia non olet · About LEMON Manuals