Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing The Clutch Actuator Cylinder

Courtesy of GENERAL MOTORS CORP.

Remove the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement .
Use a small drift or punch to remove the roll-pin retaining the hydraulic hose to the actuator cylinder.

Fig 2: Hydraulic Hose & Actuator Cylinder

Courtesy of GENERAL MOTORS CORP.

Remove the hydraulic hose from the actuator cylinder.
Drain off the excess fluid from the actuator cylinder into a container.