LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 809 (Manual Transmission Clutch System) >> Repair Instructions >> Hydraulic Clutch Hose/Pipe Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Hydraulic Hose & Actuator Cylinder
    GM180856Courtesy of GENERAL MOTORS CORP.
  1. Install the new clutch actuator cylinder hose to the clutch actuator cylinder.

    Check the new O-ring seal for proper placement on the actuator cylinder hose.

    2. Fig 2: Removing/Installing The Clutch Actuator Cylinder
    GM180855Courtesy of GENERAL MOTORS CORP.
  2. Install the actuator cylinder hose roll-pin retainer using a small drift or punch.
  3. Rotate the actuator cylinder hose to ensure freedom of movement.
  4. Install the clutch actuator cylinder. Refer to Clutch Actuator Cylinder Replacement .
scientia non olet · About LEMON Manuals