LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 808 (Lighting Systems) >> Repair Instructions >> Tail/Turn Signal Lamp Replacement (Europe, Japan) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lamp At Fascia To Tail & Turn Signal Lamp Sockets
    GM95543Courtesy of GENERAL MOTORS CORP.
  1. Remove the screws retaining the tail/turn signal lamp assembly to the rear fascia.
  2. Remove the lamp from the fascia to gain access to the tail and turn signal lamp sockets.
  3. Remove the sockets from the lamp assembly.
  4. Remove the bulbs from the sockets, if replacing the bulbs.
  5. Remove the lamp from the vehicle.
scientia non olet · About LEMON Manuals