LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 808 (Lighting Systems) >> Repair Instructions >> Position Lamp Replacement - Front (Europe Japan) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Front Position Lamp Assembly
    GM95539Courtesy of GENERAL MOTORS CORP.
  1. Position the front position lamp to the front fascia.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the front position lamp retaining screw.

    Tighten:  Tighten the front position lamp retaining screw to 2 N.m (18 lb in).

    3. Fig 2: Front Position Lamp Socket To Lamp Assembly
    GM95540Courtesy of GENERAL MOTORS CORP.
  3. Install the socket to the lamp.
  4. Close the lamp access door on top of the front fascia closeout.
    5. Fig 3: Brake Caliper Cooling Duct To Front Fascia
    GM171878Courtesy of GENERAL MOTORS CORP.
  5. Position the brake caliper cooling duct to the front fascia and press to secure.
  6. Install the front fascia lower closeout panel. Refer to Close Out Panel - Front Bumper Fascia Lower in Bumpers.
  7. Lower the vehicle.
scientia non olet · About LEMON Manuals