LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Steering Wheel And Steering Column) >> Repair Instructions >> Turn Signal Cancel Cam and Steering Shaft Upper Bearing Spring Replacement (Telescoping) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wave Washer & Steering Shaft
    GM293252Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to SIR Caution in Cautions and Notices.
  1. Disable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
    2. IMPORTANT: Let the SIR coil hang freely after removal.
  2. Remove the SIR coil from the steering column. Refer to Inflatable Restraint Steering Wheel Module Coil Replacement in SIR.
  3. Remove the wave washer (1) from the steering shaft assembly (2).
    4. Fig 2: Compressing Cam Orientation Plate Using J 23653-SIR & J 42137
    GM338052Courtesy of GENERAL MOTORS CORP.
  4. Compress the cam orientation plate using J 23653-SIR and J 42137  . See Special Tools and Equipment .
  5. Remove the bearing retainer from the steering shaft assembly.
  6. Remove J 23653-SIR and J 42137  . See Special Tools and Equipment .
  7. Dispose of the bearing retainer.
    8. Fig 3: Removing Steering Shaft & Components
    GM318239Courtesy of GENERAL MOTORS CORP.
  8. Remove the following from the steering shaft:
    1. Shaft lock shield (5)
    2. Turn signal cancel cam assembly (4)
    3. Upper bearing spring (3)
    4. Upper bearing inner race seat (2)
    5. Inner race (1)
scientia non olet · About LEMON Manuals