LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Steering Wheel And Steering Column) >> Repair Instructions >> Telescope Actuator Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Lower Trim Cover Tabs & Steering Column Close Out Trim Cover
    GM446719Courtesy of GENERAL MOTORS CORP.
  1. Install the telescope motor assembly switch and wires through the opening in the lower trim cover.
  2. Snap the wiring to the retaining clips in the lower trim cover.
  3. Route the switch wires to the telescope motor assembly along the column. Strap the wires in place.
  4. Connect the telescope motor assembly switch connector to the instrument panel wiring harness.
  5. Install the lower trim cover tabs into the steering column close out trim cover.
  6. Verify that the tabs on the lower trim cover are fully engaged with the slots in the steering column close out trim cover.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: TORX® Head Screws & Lower Trim Cover
    GM328799Courtesy of GENERAL MOTORS CORP.
  7. Install the 2 TORX® head screws (1) to the lower trim cover.

    Tighten:  Tighten the screws to 4 N.m (35 lb in).

    8. Fig 3: TORX® Head Screws, Lower Trim Cover & Driver Knee Bolster Trim Panel
    GM95692Courtesy of GENERAL MOTORS CORP.
  8. Install the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
  9. Install the tilt lever. Refer to Tilt Lever Replacement .
  10. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.
scientia non olet · About LEMON Manuals