LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 807 (Steering Wheel And Steering Column) >> Repair Instructions >> Steering Wheel Theft Deterrent Lock Replacement (Telescoping) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Wire Harness Assembly & Steering Column Jacket Assembly
    GM323839Courtesy of GENERAL MOTORS CORP.
  1. Install the steering wheel theft deterrent.
  2. Route the wire harness assembly along the steering column jacket assembly.
    3. Fig 2: Wire Harness Assembly & Wire Harness Strap
    GM323836Courtesy of GENERAL MOTORS CORP.
  3. Install the wire harness assembly (1) into the wire harness strap (2).
  4. Install the tilt head assembly. Refer to Steering Column Tilt Head Housing Replacement (Telescoping)  or Steering Column Tilt Head Housing Replacement (Manual) .
  5. Remove J 42640  from the steering column. See Special Tools and Equipment .
  6. Install the upper and lower trim covers. Refer to Steering Column Trim Covers Replacement (Telescoping)  or Steering Column Trim Covers Replacement (Manual) .
  7. Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR
scientia non olet · About LEMON Manuals