Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: TORX® Head Screws & Upper Trim Cover

Courtesy of GENERAL MOTORS CORP.

Install the upper trim cover.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Secure the upper trim cover (1) with 2 TORX® head screws (2).
Tighten: Tighten the screws to 1.4 N.m (12 lb in).

Fig 2: View Of Lower And Upper Steering Column Covers

Courtesy of GENERAL MOTORS CORP.

Perform the following steps to install the lower trim cover:
1. Verify that the slots on the lower trim cover engage with the tabs on the upper trim cover.
2. Tilt the lower trim cover up and snap the trim covers together.

Fig 3: TORX® Head Screws & Lower Trim Cover

Courtesy of GENERAL MOTORS CORP.

Install the 2 TORX® head screw (1) to the lower trim cover.
Tighten: Tighten the screws to 4 N.m (35 lb in).

Fig 4: TORX® Head Screws, Lower Trim Cover & Driver Knee Bolster Trim Panel

Courtesy of GENERAL MOTORS CORP.

Install the driver knee bolster trim panel. Refer to Trim Panel Replacement - Knee Bolster in Instrument Panel, Gages and Console.
Install the tilt lever. Refer to Tilt Lever Replacement .
Install the steering wheel. Refer to Steering Wheel Replacement .
Enable the SIR system. Refer to SIR Disabling and Enabling Zone 3 in SIR.