LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Evaporative Emission (EVAP) System Hoses/Pipes Replacement (Vacuum Supply) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Refer to Fuel and EVAP Pipe Caution in Cautions and Notices.
    Fig 1: Left Fuel Rail Cover
    GM43560Courtesy of GENERAL MOTORS CORP.
  1. Remove the left fuel rail cover.
    2. Fig 2: Intake Manifold EVAP Pipe
    GM419425Courtesy of GENERAL MOTORS CORP.
  2. Disconnect the quick-connect fittings at the intake manifold and the EVAP canister purge valve. Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Remove the EVAP pipe.
  4. Cap the intake manifold pipe and the EVAP canister purge valve in order to prevent possible contamination.
scientia non olet · About LEMON Manuals