LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 806 (Engine Controls (Introduction) -- 5.7L) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Chevrolet Corvette. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of EVAP Canister Vent Valve & Bracket
    GM329567Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent valve (2) to the vent bracket (1).
    2. Fig 2: EVAP Canister Vent Valve & Vent Hose
    GM561130Courtesy of GENERAL MOTORS CORP.
  2. Connect the vent hose (2) to the EVAP canister vent valve (1).
  3. Connect the EVAP vent valve electrical connector.
  4. For automatic transmission- equipped vehicles only, raise the right muffler. Refer to Muffler Replacement - Right in Engine Exhaust.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals