LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Controls - Removal & Installation & Overhaul) >> Ignition Systems >> Crankshaft Position Sensor >> Removal (CKP Sensor "A")

Removal (CKP Sensor "A")

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft Position (CKP) sensor "A" may also be referred to as CKP sensor 24X. CKP sensor is located behind the crankshaft balancer. See Figure. Turn the ignition off. Remove the drive belt. Raise and support the vehicle.
  2. Remove the right front tire and wheel. Remove the right engine splash shield. Install a utility stand beneath the frame right side rail in order to support the frame/powertrain. Remove the 2 frame right side bolts. Use the utility stand to lower the frame enough to provide access to the crankshaft balancer.
  3. Remove the crankshaft balancer bolt. Using Crankshaft Balancer Puller (J-24420-C), remove the crankshaft balancer. Note the routing of the CKP sensor harness before removal. Remove the harness retaining clip and bolt. Disconnect the CKP sensor electrical connector. Remove the sensor bolts. Remove the CKP sensor.
scientia non olet · About LEMON Manuals