LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Controls - Removal & Installation & Overhaul) >> Engine Sensors & Switches >> Throttle Position Sensor >> Removal

Throttle Position Sensor: Removal

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn OFF the ignition. Disconnect the Intake Air Temperature (IAT) sensor harness connector. See Figure. Remove the air inlet duct from the MAF sensor and the throttle body. Disconnect the EVAP purge line.
  2. Disconnect the fuel lines. See FUEL LINE DISCONNECT FITTINGS  under FUEL SYSTEMS. Disconnect the Throttle Position (TP) sensor electrical connector. See Figure. Remove the 2 TP sensor screws. Remove the TP sensor and "O" ring.
scientia non olet · About LEMON Manuals