LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Controls - Removal & Installation & Overhaul) >> Engine Sensors & Switches >> Throttle Position Sensor >> Installation

Throttle Position Sensor: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the NEW TP sensor "O" ring on the TP sensor. Install the TP sensor on the throttle body assembly. Install the 2 TP sensor screws, using Loctite® 262 Thread-Locking Compound (1052624), or equivalent on the screws. Tighten the TP sensor attaching screws to specification. See TORQUE SPECIFICATIONS .
  2. Connect the TP sensor electrical connector. Connect the EVAP purge line. Connect the fuel lines. Install the air intake duct. Reconnect the IAT sensor connector.
Fig 1: Locating IAC Valve & TP Sensor
G00121118Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals