LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 80 (Engine Controls - Removal & Installation & Overhaul) >> Computerized Engine Controls >> Powertrain Control Module >> Installation

Powertrain Control Module: Installation

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect the PCM electrical connectors to the PCM. Install the PCM into the air cleaner housing. Install the PCM cover to the air cleaner housing and tighten the bolts. Install the left front strut brace. Install the 3 strut brace retaining bolts. Install the coolant reservoir. Be sure to check coolant system for proper level.
  2. If a new PCM is being installed, program the PCM. See POWERTRAIN CONTROL MODULE under PROGRAMMING in SELF-DIAGNOSTICS - 3.4L MONTANA, SILHOUETTE & VENTURE article.
Fig 1: Locating Powertrain Control Module
G98I63386Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals