LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Steering Wheel And Steering Column) >> Removal & Installation >> Turn Signal Switch >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove steering wheel and SIR clockspring assembly. See STEERING WHEEL  and SIR CLOCKSPRING ASSEMBLY  . Remove lock plate retaining ring using Lock Plate Compressor (J-23653-SIR) and small tip screwdriver or scribe. See Fig 1. Remove lock plate.
  2. Remove turn signal cancel cam, upper bearing spring, upper bearing inner race seat and inner race. Remove screw retaining hazard flasher knob assembly. Remove lower instrument panel and steering column covers. Disconnect turn signal switch harness connector from vehicle harness.
  3. Tie mechanics wire to turn signal switch harness connector to ease installation of turn signal switch harness connector down through column. Remove turn signal switch from steering shaft while pulling harness up through column. To install, reverse removal procedure.
Fig 1: Removing Shaft Lock Retaining Ring
G95B13434Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals