LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 8 (Steering Wheel And Steering Column) >> Removal & Installation >> Steering Wheel Rotation Sensor >> Removal & Installation

Removal & Installation

WARNING: This page does not describe the selected car, but rather 20 other vehicles, including the 2001 Pontiac Firebird, 2001 Pontiac Bonneville, 2001 Chevrolet Monte Carlo, 2001 Chevrolet Impala, and 2001 Chevrolet Camaro. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set front wheels in straight-ahead position and turn ignition switch to LOCK position. Disconnect negative battery cable. Disable SIR system. See DISABLING & ACTIVATING AIR BAG SYSTEM . Remove bolt and nut from coupling attaching upper intermediate steering shaft assembly to lower steering shaft assembly. See Fig 1.
  2. Remove upper intermediate steering shaft assembly from lower steering shaft assembly. Disconnect electrical connector. Remove lower bearing adapter clip. Remove steering wheel rotation sensor. To install, reverse removal procedure. Tighten intermediate shaft nut to 40 ft. lbs. (54 N.m).
Fig 1: Removing Steering Wheel Rotation Sensor (Typical)
G94I32928Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals