LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2001 >> Venture Base, Van Passenger >> Repair and Diagnosis >> External Pages >> Different car >> Section 794 (Wiper System And Washer System) >> Repair Instructions >> Wiper Arm Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2002 Pontiac Montana, 2002 Oldsmobile Silhouette, and 2002 Chevrolet Venture. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn the ignition switch to the ACCY position.
  2. Set wiper switch to the PULSE position.
  3. Turn off the ignition when the wiper arms are in the innerwipe position and not moving.
  4. Disconnect the washer hose from the washer nozzle.
  5. Remove the wiper arm nut cover.
  6. Remove the wiper arm nut.
  7. Using the J 39822,  remove the wiper arm from the wiper drive system module.
  8. Remove the wiper blade from the wiper arm. Refer to Wiper Arm Blade Replacement .
    Fig 1: Removing Wiper Arm Nut & Cover
    G01813072Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals